Using the special 12mm spanner (A), tighten the bottom nuts (1) complete with O-rings (2) of both legs to the recommended tightening torque (10 Nm 1). Using a hammer, knock in introducer (A) and drive the sealing ring home into the arch-slider assembly.Īssembling: Assembling the left pumping element Insert the rebound spring (7) and the preload tube (9) ( only for models with 130mm travel ) into the piston rod (3). Insert the sealing ring (3) in its seat with the special introducer (A). Did veer proved to his family who caused the death of his brother in utaran the indian serie Pull out the pumping element (3), the rebound spring (7) and the preload tube (9).ĭismantling: Removing the seals Prize the dust seal (1) off its seat with a small flat-tip screwdriver.ĭismantling: Removing the guide bushes Use the special extractor to remove the guide bushes. Using the special 12mm spanner (A), loosen the bottom nuts (1) of both legs. Using a small pin screwdriver, blow the air off the fork leg, pushing on the air valve.
0 kommentar(er)
